Your Mac is ready to listen, but now we need to make it understand. Your Mac is now ready to listen to your record player! Getting started with Audacity and LAME Set the sensitivity of your audio input by adjusting the Input Volume slider - set it right in the middle.įinally, select Line In as the device for sound input. When we begin recording, a “crazy” Input Level bar will be a very bad thing. Note that the blue Input Level bar is at maximum. (The mic looks like a little hole in your case.) This will make the input level indicator go crazy. If you have an iMac, eMac or Apple portable, set the input to Microphone and run your finger over your Mac’s built-in mic. From the Apple menu, select System Preferences, and then select Sound. Now that your Mac can hear the recording, we need to make it listen. A headphone jack and a long enough cord like this will do the trick with a receiver or a tape deck.Īfter you plug everything in, you’re ready to rock and roll! Configure Your System Preferences You can use the headphone jack on a receiver with a phono port, or you can use another suitable pre-amp. It’s not advisable to connect a record player directly to your Mac - you know, for the lower sound quality reasons. Of course, you’ll need a cable to connect the record player to your Mac. If your Mac doesn’t have one, look into a third-party solution like Griffin’s iMic.
Not the most intuitive symbol for audio input. Most Macs have an audio input jack, like the one on our eMac: Just don’t put the resulting files on a peer-to-peer network! Connect Your Turntable to Your Macįirst, you need to connect your turntable to your Mac. While they work on that, we’re going to quietly show you how to digitize old LPs and cassette tapes. The recording industry is currently trying to figure out if we have the right to “own” digital copies of our records. We didn’t live through the heyday of vinyl, but we do own a few LPs.
0 kommentar(er)
